Telit Gps Modules of 2025
Best Choice1
Clicked 2 times in the last monthGeekstoryGeekstory BN-880 GPS Module U8 with Flash HMC5883L Compass + GPS Active Antenna Support GPS Glonass Beidou Car Navigation for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller
Main highlights- When you use it for Raspberry Pi, there is no driver needed but you need to install software
- DIts data Level is TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
- Bn 880 gps module is dual module compass, with and electronic compass IC HMC5883L
- Bn 880 gps module has flash to save configuration. So you do not need to reset next time when you use it
- BN-880 is suitable for Open source flight controller, not for flight control with SCM
9.7Exceptional
View offer on:
Show more
- Curious about how we select the top products for you? Explore How It Works
Value for Money2
ProxicastTelit LE910-NAG MiniPCIe Modem Module - 4G/LTE + GPS - 100 x 50 Mbps CAT3 MIMO
Main highlights- Supports 2G, 3G, 4G Bands B2, B4, B5, B17 -- AT&T, T-Mobile, Canadian GSM
- Rx Diversity, 2x2 MIMO and GNSS Antenna Connectors
- Firmware 17.00.503 Installed
- Embedded GPS/GLONASS Receiver
- Brand New Stock - Part Number: LE910NAG703T701
9.6Exceptional
View offer on:
Show more
3
MakerFocusMakerFocus 2 Pack GT-U7 GPS Module Satellite Navigation Positioning GPS Receiver Drone Microcontroller Compatible with NEO-6M 51 Microcontroller STM32 Arduino UNO R3 with IPEX Antenna High Sensitivity
Main highlights- With a USB interface, you can directly use the phone data cable on the computer point of view positioning effect; With IPEX antenna interface, the default distribution of active antenna, can be quickly positioned
- USB directly connected to the computer, That is, with the host computer-owned serial port function, no need for external serial module, send IPX interface active antenna
- Note: Please use the GT-U7 GPS module in an open place, the LED will flash after the satellite signal is found. Bad weather and indoor use will affect the accuracy of positioning
- GT-U7 main module GPS module using the original UBLOX 7th generation chip, Software is compatible with NEO-6M. GT-U7 module, with high sensitivity, low power consumption, miniaturization, its extremely high tracking sensitivity greatly expanded its positioning of the coverage
- GPS baud needs to be set to 9600 instead of 4800; PPS pin is not needed unless using the GPS to drive a hardware high precision clock
9.5Excellent
View offer on:
Show more
4
Beffkkip2Pack GPS Module,Navigation Satellite Positioning NEO-6M,Arduino GPS, Drone Microcontroller, GPS Receiver Compatible with 51 Microcontroller STM32 Arduino UNO R3 with Antenna High Sensitivity
Main highlights- With a USB interface, you can directly use the phone data cable on the computer point of view positioning effect; With IPEX antenna interface, the default distribution of active antenna, can be quickly positioned;
- USB directly connected to the computer, That is, with the host computer-owned serial port function, no need for external serial module, send IPX interface active antenna;
- USB directly connected to the computer, That is, with the host computer-owned serial port function, no need for external serial module, send IPX interface active antenna
- If you have any issue when using our product,or you need product use documentation, please contact us directly for assistance.we will reply your problem in 24 hours.We try our best to provide the most professional service for each customer.
- GT-U7 main module GPS module using the original UBLOX 7th generation chip, Software is compatible with NEO-6M. GT-U7 module, with high sensitivity, low power consumption, miniaturization, its extremely high tracking sensitivity greatly expanded its positioning of the coverage;
9.4Excellent
View offer on:
Show more
5
HGLRCHGLRC M100-5883 GPS Compass Module, Upgraded 10th Generation Chip Compatible with FPV Fixed-Wing UAV
Main highlights- With QMC 5883 compass: Quickly identify the directionAccurate positioning
- Stable signal: Carefully modulated ceramic antennaand external expansion PCB. Can effectively receive satellite signals
- Small and exquisite: 21mm x21mm size, Only 7.73g weight
- Quickly completesatellite search: Support GPS, Galileo, BDS three-mode positioning, fast positioning in any area
- New upgraded 10th generation chip: With compass Suitable for FPV fixed-wing UAV
9.2Excellent
View offer on:
Show more
6
Teyleten RobotTeyleten Robot ATGM336H GPS+BDS Dual-Mode Module Flight Control Satellite Positioning Navigator Replacement NEO-M8N NEO-6M for Arduino 2pcs
Main highlights- Wearable device
- Mobile phones, tablet PCs, handheld devices
- Embedded positioning device
- Car positioning in navigation
9.1Excellent
View offer on:
Show more
7
YELUFTYELUFT 2 Pack Pre-Soldered ATGM336H GPS Module GPS & BDS Dual Mode Satellite Positioning Navigator with Antenna Replacement NEO-M8N for Meshtastic GPS Arduino
Main highlights- Widely Application: ATGM336H-5N GPS module has the advantages of high sensitivity, low power consumption, low cost, etc. It is suitable for vehicle navigation and positioning, handheld positioning, wearable devices, embedded positioning devices
- Supports A-GNSS Function: A-GNSS can provide the receiver with the necessary auxiliary information for positioning, such as telegrams, rough position and time. Whether in strong or weak signal environments, this information can significantly shorten the first positioning time
- Outstanding Performance: Based on AT6558, including 32 tracking channels, ATGM336H GPS module supports A-GNSS and can receive GNSS signals from six satellite navigation systems at the same time, realize joint positioning, navigation and timing
- Note: When using GPS module, try to take the computer to outdoors. If you use it indoors, affected by the distance between the buildings, obstructions and other factors, there is a certain chance of positioning failure. The first time positioning outdoors is usually within one minute, onboard LED keeps flashing at a certain frequency means successful positioning
- Accurate Positioning: Positioning accuracy is 2.5 meters(CEP50, open place), first-time positioning time is only 32 seconds, excellent positioning and navigation function, supports single-system positioning of BDS/GPS navigation systems, as well as multi-system joint positioning in any combination
9.0Excellent
View offer on:
Show more
8
GeekstoryGeekstory BE-180 GPS Module Beidou GPS AntennaTTL Level 38400bps for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller
Main highlights- What you will get: 1*BE-180 GPS Module; 1*1.00mm 4pins Cable; 1* 20cm 1.0mm 4P Connector Male Cable
- This BE-180 GPS Module using the latest 10th generation chip When you use it for Raspberry Pi, there is no driver needed. Here is connection with RPi, red to 3.3v, black to gnd, green to txd, white to rxd
- This BE-180 GPS Module has Flash to save configuration, so you do not need to reset data next time when you use it.. Baud Rate : 4800bps to 921600bps, Default 38400bps
- The TX LED flash means gps module output normally. The PPS LED flash means gps module locate your place
- Data Level : TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
8.8Very Good
View offer on:
Show more
9
GeekstoryGeekstory DY-180TTL GPS Receiver Module Dual Glonass GPS Navigation Module TTL Level 9600bps with GPS Antenna for Arduino FPV Aircraft,Replace BN-180 GPS
Main highlights- What you will get: 1 X DY-180TTL GPS Module, 3 X 4P 1.0mm Pitch Cable
- This DY-180TTL GPS Module does not have FLASH and cannot be saved. 72 Searching Channel Support Rate : 4800bps to 921600bps, Default 9600bps
- This DY-180 TTL GPS Module can show your speed. When you use it for Raspberry Pi, there is no driver needed. Here is connection with RPi, red to 3.3v, black to gnd, green to txd, white to rxd
- The PW LED flash means gps module output normally. The PPS LED flash means gps module locate your place. Note: without PPS output, only PPS indicator
- Data Level : TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable
8.6Very Good
View offer on:
Show more
10
DWEIIDWEII 3 Set GY-NEO6MV2 NEO-6M GPS Module NEO6MV2 with Flight Control EEPROM MWC APM2.5 Large Antenna for for Arduino EEPROM APM 2.5 (3PCS)
Main highlights- With data backup battery;With LED signal indicator
- Module with ceramic edge antenna, super signal.
- GPS modules NEO-6M, 3V-5V power supply Universal
- Default baud rate: 9600, Interface: RS232 TTL
- Compatible with various flight control modules that provide GPS computer test software
8.5Good
View offer on:
Show more
Similar products on Amazon
